In this instance, it works in the same way as an additional bracket and gives extra support. The prop will usually go from the base of the closet to the top and have a section that protrudes from it that the prop can sit in. Add a PropĪlternatively, you can add a prop underneath the rod. Ensure the brackets are fixed firmly to the back wall of the closet or, alternatively, add a shelf with brackets that hang down from the bottom. Alternative, you can measure the distance from the wall and the external diameter of the rod and make your own or buy them ready made. Ideally, you can just measure the existing brackets and try to buy additional ones with exactly the same dimensions. Adding two brackets along the pole gives even greater strength. Adding a bracket in the middle of the rod will provide additional support. If this is all the support that the rod has, and especially if it is a long rod, it won’t take much weight before the rod sags. Add an Extra Bracket or TwoĪt the very least, closet rods are held up by a bracket at each end. This method allows you to keep the look of the existing dowel while providing it with the extra strength it needs. The tighter the fit, the less likely there will be any sagging, but if the internal dowel is too tight, you might struggle to get it all the way through. Push the solid rod inside the hollow rod, saw it down to size, and replace it in the closet. Measure the internal diameter of the rod and get a solid wooden dowel with a slightly smaller diameter. In either case, a hollow rod is more likely to crease, fold, or otherwise bend, causing it to sag.
Others use metal because the material better suits the aesthetic of the closet.
Make a Hollow Rod SolidĪlthough a decent quality length of wood costs very little money, some closet manufacturers still insist on using hollow plastic rods. There are also a few steps you can take and ideas you can try implementing to stop the sag or prevent one from happening.
Often, either because the rod itself becomes misshapen or because the fastenings holding the rod up have weakened, the closet rod can sag.Ī sagging rod can lead to crumpled clothes, and it means that all hangers and clothes will tend to slide towards the sagging area, further exacerbating the problem.įortunately, the rod itself is typically just a length of metal or wood, and the brackets used to secure them are readily available, so replacement isn’t too big a deal. It should keep clothes away from the base of the wardrobe or shelves below. A closet rod allows you to hang clothes neatly, well-spaced, and with room between garments to allow airflow.
0 kommentar(er)
